The Nissin Di622 Digital TTL Shoe Mount Flash is designed to support digital cameras as well as film SLR cameras. With features like auto-zoom, tilt and swivel head, 6 power ratio settings, and built-in slave function, this flash is ready for any situation.
This flash supports the latest versions of TTL operation, including E-TTL II for Canon and i-TTL for Nikon, and can also be used with digital cameras.
Its AF assist light can help the camera to focus in low-light conditions. The vertical tilted reflector allows for effective composition of photos, and a built-in catch light reflector can be used to further improve the light composition.
- Goes into sleep mode after 30 seconds of idling, and to power saving mode after 5 minutes
- Includes built-in wide angle diffuser and catch light reflector
Di622 is compatible with Canon’s E-TTL, E-TTLII system, and Nikon’s i-TTL system.
Those new digital TTL flash systems control the flash light with greater precision and stability.
POWER ZOOM & TURNING FLASH HEAD
The light distribution angle is automatically adjusted for the lens focal length. A high quality stepping motor sharply traces the lens movement with the same speed as that of the camera manufacturer’s original flash model.
PanelThe flash beam covers the frame from 14mm (with a wide angle diffuser built-in) to 70mm of the digital lens.(*) For a longer lens, the flash head reflector position stays at 70mm.
It turns 90 degrees upward and 270 degrees horizontally for bounce lighting.
BounceThe flash head also stores a small reflection panel for fill-in shots.
OFF CAMERA FLASH
Remote The Di622 has a special photo sensor built-in.
Place the Di622 off camera and the flash will synchronize with the master flash placed on your camera. This wireless remote flash system is called slave flash technology and is often used for a creative lighting efficiency.
Use the camera’s built in flash, the camera manufacture’s original flash or the Di622 as the master flash. Place one or more Di622 flash units away from the camera.
The sensor circuitry of Di622 is compatible only with the latest pre-flash TTL system offered by Canon or Nikon
The Di622 is not compatible with traditional flash systems or studio flash systems.
Energy saving system
The Di622 has a dual energy saving system.
It automatically enters sleep mode when it’s not in use for 5 min., and is reset with a touch of the shutter button or any button of the flash.
If the unit is not in use for 30 minutes, it will automatically power off.
With the flash unit set for slave mode, sleep mode is cancelled and the unit will not automatically turn off until 60 minutes have elapsed.
G.No.62(ISO 200) is obtained at the reflector position for 105mm focal length lens, and 45 at 35mm. (Reference: The guide number of the flash built in the camera is16 approx. at ISO 200)
When selecting manual power operation, choose from one of the six variable powers for the best lighting effect.
The power level is provided from full power (G.No.62) down to 1/32nd power in 1.0Ev increments.
AF Assist beam
In darkness or dim light conditions, the Di622 beams a red light to create a sharp contrast to enable the camera’s focus sensor to focus easily on the subject.
Flash Power Lock system
The Di622 is compatible with either the FE lock (Canon) or FV lock (Nikon) system.
Refer to the camera owner’s manual for details.
Rear curtainsynchro. system
Nikon and some Canon camerra’s set the flash for rear curtain synch. photography.
The Di622 follows the command signal of theses cameras.
Red Eye reduction
Available with Nikon cameras only. A small flash beam is automatically produced for short distance portrait shots to prevent the red-eye phenomenon.